Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Firmware recovery on the RV180x is possible and in fact simpler than on previous models. This also works on the RV130x but the web page looks slightly different. This is for when the RV180W is alternating flashing of the System and Wireless lights, a...
What VLANs can see each other is based on the IPsec policy at each end. So if you had on side A Local Security group 192.168.200.0\24Remote Security Group 192.168.1.0\24And on side BLocal Security group 192.168.1.0\24Remote Security group 192.168.200...
Yes, the VLANs will see each other. The only problem you run into with networks and VPNs is if the Subnets overlap. There is no VLAN tagging sent over the VPN so they are not aware of the VLANs on the other side of the VPN tunnel, just the networks.
In the Router configuration under System Management -> Dual Wan you can set up the behavior of each WAN interface. All you will need to do is tick "Smart Link Backup," select the primary WAN interface and save the configuration.
I think that the best solution would be to use a Dual WAN router rather than having 2 different routers and setting up fail-over between them. The RV320 and RV325 both support dual WAN with fail-over, load balancing or protocol binding. What is the s...
