Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All;
I was deploying Prime Infrastructure 3.1, license has been installed, I was trying to add the following PIDs of nexus switches: C93108TC-EX, C9272Q, C92160YC-X. Unfortunately these devices appears as Unsupported device type.
When I've check...
Hi all;
I was trying to upgrade FXOS in Firepower chassis Manager (FPR4100) to 2.1.1.73 version, once the upgrade completed the chassis reloaded but unfortunately I lose communication with the chassis management port, When I've checked it through con...
Hi;
I am Trying to configure snmp V3 over nexus 9000 switches running 7.0(3)I1(3), it seems that The priv option (Privacy password )along with the aes-256 is not supported through NX-OS.
can anybody advice me about that as this is required from the c...
Hi all;
I have configured LMS 4.2 to receive snmp traps from my network devices, and by debugging the snmp packets it seems that the configuration working well as the LMS polling the devices every 2 minutes.
The problem is that the topology servi...
Hi all;I am asking about the Failover (Active/Active) on asa 5525-x SFR.I am configuring Failover(Active/Active), and make sure that the configuration of the failover is correct, between the tow appliances.But when issuing the command failover on the...
Thanks for reply, I've connected to the chassis using console and try to revert back to the old image 1.1(4.95) using /firmware/auto-install # install platform platform-vers 1.1(4.95)
but I get the same crash logs, so the management port as well Fibe...
thanks for reply, Yes I upgraded FX-OS from older version as you can see from table below:
firepower /firmware # show package Name Version--------------------------------------------- -------fxos-k9.1.1.4.95.SPA 1.1(4.95)fxos-k9.2.1.1.73.SPA 2.1(1.73...
Dear jossabor;
Thanks for clarification, but is that even planned in the road map? we are now comparing LMS with the other products (non-cisco) monitoring tools.
As you know the other products gives you a map with the devices status "auto refreshed" ...
Hello Andre; Thanks for your reply. I have checked the software module and it was need a recovery.So i issue the recovery commands for the SFR module.It is done. Regards
