I have two servers, both with SSD drives, copying large files using the 10 gb SFP ports on this switch. However, network performance seems to be poor. I typically see 1 - 2 gbps of throughput.
What might be some reasons for low throughput?
I need to change the MTU size on a specific VLAN on the Cisco SG500x. However, I don't see an option to adjust the mtu size under the VLAN interface. How else can this be accomplished? switchcd71c1(config)#int vlan 100switchcd71c1(config-if)# brid...
Just for my understanding, in which scenario would one be able to even use jumbo frames at every port? Wouldn't every single device connected into it be required to also be configured with jumbo frames?
That's disappointing to hear. I have my uplink port from this switch go directly to the ISP's switch. They will not configure jumbo frames on their side.1. I assume there is no way to exclude a port to have jumbo frames on?2. Is there a roadmap to b...
it looks like I do have the option to enable "port jumbo-frame" under a VLAN or physical interfaceswitchcd71c1(config)#interface gigabitethernet1/16switchcd71c1(config-if)#port jumbo-frameHowever, once I configure it the port jumbo-frame shows up in ...
