I have a site-site VPN tunnel configured. To access it you have to go thru a DMZ off of my PIX. Trafficgoing thru the DMZ interface is translated to a global hide IP address. I am attempting to access the remote network (other side of site-site VPN) ...

I have a router running 12.1. Can I somehow bind a specific isakmp policyto a particular section of a crypto map or even bind an isakamp policy to one peer? ThanksGeorge Feldman

I have two machines using NAT and hiding behind one global IP.One client is successful in connecting to the PIX using Cisco VPN Client 3.6.1.However , when the second client tries to connect, the client cannot connect and gets a Peer not responding e...

I need to enable NAT on a cisco router. There are three interfaces,serial0, ether0, and ether1. Ether0=10.100.1.1 /24 and ether1=10.200.1.1 /24.I need to translate the address 10.100.1.2 to address 10.201.1.2. There isa route to 10.201.1.x /24 thru i...

I am building a router to router IPSEC VPN. The ether interface on one router willhave a private address which will be one-to-one statically translated on a firewall.I will bind the crypto map to this NATd ether interface. The other router has a publ...