Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I need some help figuring something out with STP.My environment is still begin setup up, consists of the followingCore switch 1 - Root bridge priority 0Core switch 2 - priority 4096Stack A - 2 switches, switch connected to the core switch 1 primar...
Hi.I have an issue that one of my 9300-M does not want to have a statically assigned IP address in my management VLAN. This unit is the Primary in a warm spare and has L3 interfaces configured with also the management VLAN gateway (VLAN140).It is a t...
I need some assitance with using NetFlow in combination with WCCP.
We have a firewall enabled with WCCP and NetFlow exporting the flow to a NetFlow analyzer. The issue at hand is that all traffic that is redirected by the WCCP rule, shows as the IP...
Hi all,
I have succesfully registered a 9951 Phone to CME, and am able to place calls/called from internal numbers.
The issue I am having is placing/receiving calls from the outside world.
My config: (If anything else is needed, please ask)
v...
Hi Philip, to answer your questions:* Forgot to put it in the image, but the Core switch 1 is configred as an L3 switch with VLAN gateways, the Core switch 2 is the warm spare for this. Switch 1 and Switch 2 are linked together with an aggregate trun...
I checked the firewalls, no blockades there.Maybe because I try to assign the switch an IP address as management IP where the switch itself is the gateway for?When I go to to Tools page and use the Management Gateway IP for the ping to dashboard.mera...