Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I can no longer access the local status pace using the appliance vlan local gateway address, I get redirected to an address that looks like this: https://<mac-address>.devices.meraki.direct:8092/index.html where <mac-address> = appliance mac address....
Has anyone experience an issue with a FQDN in a firewall rule not resolving?I have the following example (addresses and FQDN have been anonymized):Policy = AllowRule Description = PayrollProtocol = TCPSource = 192.168.20.0/24Source port = AnyDestinat...
I have two MS120-24P switches equipped with 1000BASE-SX: 1.3 Gbps SFP modules on port 28, and connected to each other with MM fibre. The second switch (call it MS02) was issuing UDLD alerts on the port, but there was no UDLD alerts on port 28 of MS01...
I have enabled Netflow on Meraki MX appliances, defined the collector address and port number, and the OpManager netflow collector is recording the data. The charts I am getting however have no correlation with what is reported on the historical devi...
Hi All,I am trying to install the above appliance with a 5G capable SIM with the help of remote hands. I have no physical access to the appliance. The appliance network was created on the dashboard, SIM was installed and the appliance was powered up....
Thanks, packet capture isn't that easy because there's a 12 hour time difference between me in London, and the problem location in New Zealand. I've added the FQDN IP address into the rule as a workaround and I won't be able to remove that until the ...
Thanks, for the response. As far as I can see the FQDN complies with all the requirements in the link you provided. Access to the DNS server is not intra-vlan, and the powershell script "test-netconnection online.imspayroll.co.nz -port 491" also fail...
Thanks for the responseThe address was anonymized but there's no real need for that. It's actual FQDN is online.imspayroll.co.nz and it resolves correctly to 13.210.191.42 in the MX status page in tools.
The packet counter on the interface aren't incrementing so there's nothing happening on the port. A packet capture is empty. It's behaving in the same way a port would if connected to a media converter with link fault pass through set to off. That i...
The only plausible explanation that I can think of is that there is a repeater/bridge in the fibre that maintains link layer connectivity on the B end, but the cabling contractor insists that it's pure end to end fibre. Unfortunately I'm in London an...
