Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm having several issues trying to configure a CSM, positioned in a Cat 6509.I believe our configuration is "one-armed" based on advice from our SE, though I've deviated so much from our initial config this may not still be the case!As a simple test...
I've configured a 6500 FWSM module in transparent mode with multiple contexts and SSH is used to login.Unfortunately I'm struggling with the easy bit - I've created a local username/psasword with privilege level 15 but the only username the FWSM will...
Hi,Its been a long day....We have a 6509, with FWSM operating in transparent bridging mode and have CSM configured in one arm mode.We are seeing very mixed results, load balancing appears to work however when we ping the VIP address from the servers ...
Can anybody advise on how to force a router to create a warmstart trap for test purposes?From the RFC - 4.1.6.1. The coldStart Trap A coldStart(0) trap signifies that the sending protocol entity is reinitializing itself such that the agent's confi...
Hi,We have the following scenario -|--R1---Z---R2---(cloud)---R3---Z---R4---| |-----------GRE Tunnel----------|Z are external cryptos, we have a GRE tunnel between R1 and R4 (the lines don't line up!!). Traffic passes through the tunnel fine....
If it is of value my final config is below:module ContentSwitchingModule 1 variable ROUTE_UNKNOWN_FLOW_PKTS 2! ft group 1 vlan 4 priority 20 preempt ! vlan 40 server ip address 172.16.96.67 255.255.255.248 gateway 172.16.96.70 alias 172.16.96....
Thanks for the response.Your post prompted me that I was heading away from the original requirement - one armed design, The Default Gateway for servers is the MSFC.I've stepped back a few stages and applied a nat pool and "client nat", then everythin...
Thanks, we worked out what we were doing wrong this morning....We have a redundant FWSM in another chassis which we "thought" we had disconnected.I was making changes on the primary (which should have been the only one in the network) unfortunately w...
This matter is now resolved.We found that by adding probes everything worked fine.We did initially try probes but couldn't get them to work - because we added an IP address to the probe config...We also needed to set recover as the default didn't see...
I raised a TAC case as we had the same question, the response is:The answer to your question is to be found in the QoS Faq at :http://www.cisco.com/en/US/partner/tech/tk543/tk545/technologies_q_and_a_item09186a00800cdfab.shtmlQ. How many classes does...
