SGE2000 problems: 1) Layer 3 stack routing (?) problem after slave unit restarts. Greetings! Firmware: 3.0.0.18 Boot code: 20003 The scheme: ----- LAN1         SGE2000 Level 3 stack:                `-----------Unit 2 (slave)                            Unit 1 (master)                            /                            \                             `----------(ws1) The problem scenario:             NB: It is only applicable to the situation when we use different subnets, in other words,             the Layer 3 functionality of SGE2000 is involved. No such issues appear when all the hosts             are in one VLAN, whether they are connected to different units in a stack or not.             If the connection between Unit 1 and 2 is lost (I unplug the cable), slave unit ( Unit 2 ) resets,             and comes up back to operation as a slave. It's OK.             But the host ws1 (from LAN2) is not able to communicate to cmputers in LAN1 after the event.             If I go to the web interface of the stack and do the ARP-table flush, some pings may pass             but the next second the connectivity is lost again.             All the ports involved in communication are in "forwarding" state.             Sometimes, if I do a manual flush on Dynamic table in Bridging, communication             becomes OK. Sometimes it doesn't help. Even if flushing arp cache too.             If I unplug ws1 from the switch and plug it back, the connectivity becomes OK.                  Flushing arp cache on ws1 doesn't help.             If I restart the whole stack, the connectivity is OK.             What's the problem with restarting a slave unit? Why the routing connectivity is lost? -------------------------------------- 2) Another problem is when trying to bind an ACL to the interface      it simply reports: Line No. Error Type Value Diagnostic 1 Unknown value Cannot apply because lack of HW resources..      =) Great! ... View more