Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi allI am new to the community and I work for a 3rd party IT support company. I have been directed to the community support site by a cisco TAC engineer. I would like to know what recommendations Cisco would make for servicing/cleaning a core switch...
The bridge-group should show up in the config if it was configured. You can issue a "show span" and see if that token ring interface is forwarding within the bridge-group. If you see the token ring interface listed in the show span then it really i...
Is the router connected to a hub/mau or switch? A typicaly SNA workstation will send a "local" explorer (does not contact a RIF) and a source routed explorer. If your router is configured for source routing on the physical token ring then it will b...
Hello,Can you describe what you are trying to accomplish? Do you want all 3 ISL connected switches to be connected to the same physical ring? If so, then your description of the problem and answer are correct. You will need to create 3 different B...
Unfortunately, GRE tunnels will not work in this case. BPS does not use the same signalling as HDLC, therefore when the chipset is configured for HDLC it will not know the start stop characters of the frame. Sync BPS is not supported due to the bst...
