Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am trying to input the following config lines into a new stack of 9300's that I have. The stack is currently working on SW version 17.06.05. However, when I try and input the configuration it tells me the commands are deprecated and to use 'a...
Hello,I am looking for some advice on how to run a particular type of report / audit within ISE. For some backstory, we are experiencing some issues with high CPU & Memory. We are also finding there is a lot of latency within the database.We currentl...
Hello,I have been asked by Cisco TAC to collect 'ISE PSC log files'. I am unsure on where to collect these, or if they fall under a different name.Are they collected by the GUI or CLI?ISE version - 3.0.0.458Thanks!
Hello @klnnnnng - It wasn't a case of seeing why endpoints had been rejected, it was more to see the last active endpoints.For example, we have recently swapped out thousands of IP phones, however the MAC's were not removed from the identity group. B...
I did try here earlier with the advanced filters, to try and narrow it down to devices that had not registered. Unfortunately, the filter doesn't allow this.I would have thought this would be possible under operation>reports>endpoints and users>regis...