Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Two 2811 routers, both on 12.4(13r)T5 software.Each has a VTI interace. VTI works great, i'm running ospf across it which also is working well. My problem is that if i shut down the ethernet interface (through software or unplugging) on router A, t...
Have a PXI501 on 6.3(5) connecting to a PIX515 also 6.3.(5). Have 20 other's in the exact same configuration (connecting to same PIX515). Yesterady PIX501 stopped sending traffic over tunnel. I'm pulling my hair out.The tunnel comes up fine, no er...
I have a Dailer interface with two BRIs that belong to it. I use the BRIs to backup a frame relay circuit. I have to support up to 256k of bandwidth so i needed four bearer channels. I recently had a problem with the ISDN line that is BRI1/1. I n...
Had tried that, and rebooted the 501 (and pointed it at a new 515).Sorry, I know UDP 500 is just for ike (and obviously I see that traffic landing during negotiation).I actually solved problem by rebooting an upstream router. At this location I (unf...
Well, currently there is an issue with one of the ISDN lines for example. BRI1/1 spids are not sent/valid so that line can't dial or do anything. If i administratively down BRI1/1 then it will switch to dial backup and use BRI1/0. However, so long...
