Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an ASA 5510 with the newest OS. The ASA is connected to a broadband internet connection.Is there a way to limit per user traffic to a proportional subset of the total available bandwidth. As an example suppose a single user is accessing the in...
I have two sites connected utilizing IPSEC with an ASA 5510 at each site. A T1 is terminated at both sites by the ASA. A site-to-site IPSEC vpn is established through the ASA. Traffic at the main site flows from the ASA 5510 to a Catalyst 4507.We now...
I have an ASA 5510 that currently resides at the perimeter of the network with internet connectivity provided by routable IP handoff to ethernet. I have multiple internal VLANs and have a separate cable internet connection for non-critical traffic. W...
I'm having a hard time understanding the difference between the following commands. class-map match-any Nameclass-map type inspect match-any Namepolicy-map Namepolicy-map type inspect NameAlso a policy-map of type inspect can apparently have a regula...
I have a remote site connecting to a secondary site using a GRE tunnel. The remote site has a second GRE tunnel to the main office. The remote site and secondary site are connected to allow VoIP traffic. I am having intermittent bandwidth issues resu...
I hadn't even thought about SLA, that will definitely help.PBR is required since specific internal subnets access the internet using one ASA while other internal subnets access the internet using the second ASA.I believe I would set up an identical V...
Here's an example I made real quick. In both the class-map and class-map type inspect I'm inspecting edonkey traffic. Can either of these be used for ZBF?Is class-map typically used just for QoS while class-map type inspect is used for ZBF? Also when...
As soon as I put "ip tcp adjust-mss 1300" into the Tunnel interface on the spoke side I was able to connect to intranet sites.Can you provide a summary of what would cause that one command to allow clients proper connectivity? I'd like to better unde...
I can ping across normally, RDP will often disconnect. In general the connection across the GRE tunnel seems much slower than across the old IPSEC connection.Right now I'm using MTU 1400 as found in this document, http://www.cisco.com/en/US/tech/tk58...
