Hello,
what happened if WLC HA link goes down in cluster? Will both WLCs go active? Is it affected the production? We are using version 8.0.115.0, model 5508 using redundancy state SSO.
thanks
Hello,
Q1:
We are using WLC WISM1 with SW version 7.0.240.0. Is there any possibility to write output out from h-reap WLAN-to-VLAN mapping only? I dont want to use complex command "show ap config general". Our goal is then create python script with ...
Hello, The IEEE required only mandatory support of data rates of 6, 12, 24 Mbps, the reason behind this because each of these rates using a different modulation ( BPSK,QPSK and QAM). Some (very few) 5G capable client drivers were written to accept on...
Starting with Release 7.0(3)I2(1) and later releases, there is a single image for booting the Cisco Nexus 3000 Series platforms. The kickstart and system images are not required anymore. The single image binary now boots up on both Cisco Nexus 3000 a...
Hello,thank you for this useful post. Regarding Coverage Hole Detection & Correction. As you have written, this is done by per controller and there is no interaction with other WLCs. What if we have both WLCs under one mobility group and APs spread a...
Hello Rasika,
I would like to ask you for a specific question. It is better to use client load balancing or use Assisted roaming Prediction Optimization? Both cannot be enabled together.
Thank you