About Inkmouse

Inkmouse · 12-23-2024

I'm looking for a solution to be able to shift traffic across multiple wan links on individual edges on an over arching HUB Spoke topology.Example HUB A has a singular transport however Spoke B and C have multiple transports such as LEO, cellular/LTE...

Inkmouse · 07-11-2024

Even through I know from a nested support stance Junipers official take is that the new vJunos Router images are not supported unless on BareMetal installs. However I know people in the EVE-NG community have successfully gotten it to load by using mo...

Inkmouse · 01-02-2025

Kanan's information was super helpful and I didn't realize that when playing around in the centralized policy that I could use multiple (sub-policies). In the end I used a (topology -> HUB and Spoke policy combined with a topology -> custom route & t...

Inkmouse · 07-12-2024

You will access the web GUI for SD-WAN Manager from the non management IP address that you assigned to vpn 0. Also note that after you turn the SD-WAN Manager node on it can take 15+ minutes for the GUI to fully initialize.

Inkmouse · 07-11-2024

little late on this reply. However you do not necessarily need a smart account in order to do SDWAN in cml. The smart account is associated with licensing and Plug N Play connectivity when using SDWAN along with associating vBond profiles to your Plu...

Member Since	‎07-11-2024 07:39 AM
Date Last Visited	‎12-30-2024 09:24 AM
Posts	5
Total Helpful Votes Received	1

User Statistics

User Activity

Edge router TLOC selection preference

Newer vJunos Router node definition

Re: Edge router TLOC selection preference

Re: Access to Cisco SD-WAN Manager via GUI

Re: CML 2.7 - SD WAN license needed?