Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiOnce a month I have my OSPF hello packets eaten by the router or upstream ISP prompting dead timer expiration, which is set for 8 seconds instead of the default of 40 seconds. This upstream ISP has a 8 second acceptable outage written into the sign...
I notice this configuration in production that is different than the Cisco recommended configuration. Is this worth correcting or should we leave it alone? The issue is the VIP IP is the same as the SVI IP address and not a third unique IP. It seems ...
I have 9 of 100 network devices fail every Sunday when SolarWinds runs a config backup job. I can't ssh to them either when I run a manual SSH from Putty on the SolarWinds server. Well, 7 of the 9 are unreachable. I can ping all 9 of them. I give up...
HiCorrection: The switch is having this issue not the ISR. I can't delete the thread. Our Cisco ISR 4331 (IOS 16.6.4) is shown in SolarWinds has having a steady temperature of 104-105F degrees. The Cisco documentation says operating temperature is ...
I get these periodically during the day on the router syslog. Feb 16 19:33:22.817 EDT: %RADIUS-4-RADIUS_DEAD: RADIUS server x.x.x.x:1645,1646 is not responding.Feb 16 19:33:22.817 EDT: %RADIUS-4-RADIUS_ALIVE: RADIUS server x.x.x.x:1645,1646 is being ...
Note: S1 is backup for VLAN 16Note: S2 is master for VLAN 16. Note: S1 and S2 are connected via a port channel. I can't reconcile why VLAN 16 traffic on S2 is RX traffic with Tx 0 and why VLAN 16 on S1 is Tx traffic and Rx (0). The upstream router i...
Also, you conducted this test on a router with IOS-XE. I have two Cisco Catalyst 9k switches. Are the effects the same? Also, the IOS XE documentation doesn't mention the VIP being the same as interface IP gives priority of 255. It only says this: "I...
Yes. Thank your for mocking this up in GNS3. This is very disconcerting as I presume the intention is to have switch1 as the master since OSPF has a lower cost than switch2. I'll mention it to management but they will probably ignore it. I will come ...
TeamAs it turns out that second Radius server was decommissioned 6 months ago. I need to rebuilt it using the same line in the configuration and the IP. Currently they have a Windows Radius solution. Should I just build a second Windows Radius server...
