Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day Gentle People,I mounted 3 Cisco 9300 switches as stack of 3. I know the lower MAC takes the priority, so I changed the priority to 15,14 and 13 to switch 1,2 and 3 and re-numbered accordingly. But the interfaces are still showing as they we...
Good day Pros.I would like to ask from the Experts what do they think about the compatibly for the following devices, for our upcoming project? Please check attached file.Please let me know what are their opinion/Recommendation for Cisco Catalyst 930...
Very good day pros.I have STIGs compliance to upgrade 9200 (Stack2 switches) from current IOS (cat9k_lite_iosxe.17.12.05.SPA.conf) to (17.12.06). I have have uploaded (cat9k_lite_iosxe.17.12.06.SPA.bin) and waiting for for the scheduled down time.My ...
Hello Pros,
I wanted to add Time Stamp on my 9200 Switch to the Syslog Backup server, if any one make change on the switch every time/any time. My management can see.
We are using Unix backup server and we can see any change. But it does not show th...
Hello Pros.
I recently installed two Cisco 9200 C9200L-48PL-4X (Stack wise) and upgrade to IOS (17.12.05 CAT9K_LITE_IOSXE). When I checked show version I found something that I never paid attention and don't know what is that mean and how to resolve...
Leo,Thanks for your response. I did re-booted switch numbers have been changed but the interfaces are still looking same. Like the Top switch is sw1 (Active) and interfaces are Gi3/0/2, Gi3/0/3 and so on, SW2 in the (Member) Interfaces are Gi1/0/1 et...
Good day Gentle People,
I mounted 3 Cisco 9300 switches as stack of 3. I know the lower MAC takes the priority, so I changed the priority to 15,14 and 13 to switch 1,2 and 3 and re-numbered accordingly. But the interfaces are still showing as they w...
Stefan,Thanks for your response. Could you mind to share the steps and commands. I know how to upgrade a single switch but I think the stack upgrade has different process and commands. Much appreciated and thanks in advanced. Zee-Far-Man
