Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Please let me know where to download the Cisco USB Console Driver for Windows 10. I found the Cisco_usbconsole_driver_3_1.zip. But after I installed it, in Device Manager, under Ports (COM, LPT), I do not see a Serial USB Port. Thank you so much.S...
Good morning,I have very little Cisco experience, just joined a new organization, and was told to learn about the Cisco C9500-24/48Y4C switches. The switches were configured before but the person left and we lost everything. I know the default value...
Hi Leo Laohoo,With your help, I successfully somewhat inFactory reset -all a C9500-24Y4CFrom ROMmon, boot from TFTP, cat9k_iosex.17.14.01.SPA.binNo to initial configurationSet enable secretSet IP address of Management Port:switch#configure terminalsw...
Leo Laohoo,Thank you so much for your response regarding MAC address, S/N, ... butFrom: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9500/software/release/17-11/configuration_guide/sys_mgmt/b_1711_sys_mgmt_9500_cg/simplified_factory_res...
Hello marce1000,Thank you so much for your response. I have some follow up questions before I will try:My ROMmon prompt is 'rommon1>', not 'switch:' Is that OK to proceed?the command to set IP address of 192.168.1.2 is to which interface of the swi...
Good morning,I just started a new job with very little Cisco experience but was asked to start learning some Cisco switches (C9500-24/48Y4C). The switches were configured before, but the person left, and we have no way to get into the switches. I f...
Leo Laohoo,Thank you so much for your response. I read somewhere that the IOS image can be reloaded via USB flash drive or TFTP. The government does not allow us to use USB flash drive at all. Would you please give me more detailed instruction how...