Ladies/Gents:I recently discovered that two of the switches on my network were sharing the same IP. My IT guy says it doesn't matter because the assigned IP is for switch management only and should not affect traffic. We do minimal configuration out ...
Ladies/Gents:Is there a trunking port limit on Cisco switches? I have a 9300L that has 4 SFP ports. Currently using 3 of the ports to trunk to other Cisco switches without issue.Thanks,Mark
Switches: 2960G & C9300LUse: Carrying audioTried connecting a cisco 2960g to a Cisco C9300L via SFP ports. The 9300L kills the audio within 3 seconds for the two studios that are on that switch when I plug the SFP adapter into it. I know the 2960g of...
Here are the commands that are run on all switches in this network to prepare for linking to each other:interface Gi1/0/x (x=the Ethernet port being configured)switchport mode trunkswitchport nonegotiateno ip igmp snooping tcn floodend
Please see attached diagram. I am just having a hard time understanding why the 9300 would behave this way when the third SFP port is plugged in. It did not behave this way when the C1000s where plugged in.
Todd:Fiber. No error messages. Running the "sh inv" command shows the adapter description without issue. Very limited troubleshooting I can do real time. Originally, I was trying to bring up a legacy 2960 on one of the 9300Ls trunk ports. Every time ...
