Hi Experts,I have a basic question in private vlan. I have two switches SW1 and SW2 connected back to back via a port channel.on SW1, i have configured the following.vlan 990
private-vlan primary
private-vlan association 991-994
vlan 991-993
pr...
Hi Experts,I'm trying to set the metric using rout-map but have some problem in making it work. need little assistance.SW2# sh ip route 11.11.11.011.11.11.0/24, ubest/mbest: 11/0 via 10.10.10.10, [200/0], 00:00:04, bgp-1, internal, tag 1SW2# sh r...
Hello Experts,I'm new to Multicast and still on the porcess of learning the fundamental and undestanding the concepts. please ignore if this sounds a basic question.I have two N3K switches Connected back to back via port-channel.SW1 -----------------...
Hi Experts,Need assistance in configuring the ntp....I have a switch which also serves as a dhcp server to the hosts connected to it.The switch serves IP address too the devices connected to it and i would also want it to provide time to the connect...
Hi Experts,Would like to get assistance on the following issue that i'm currently facing.I have the setup as follows:Internet --------------> Router --------------------> SWitch ---------------> HostsRouter is acting as the default gateway and has an...
oh.. my bad...stupid mistake.i actually wanted to modify the AD of a particular route. I could not see that option under route-map. is there any option?Thanks,-Vijay
I would not recommend using Portfast for switch -switch interconnectivity. typically we configure portfast only on Edge ports. since this is not an edge port i would just configure "switchmode mode trunk" on both the links connnecting those two switc...