Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone, I can't find way how to set up ASA 5520 with ipv6 on pppoe on G0/0:!interface GigabitEthernet0/0 nameif External-00 security-level 0 pppoe client vpdn group WAN ip address pppoe setroute ipv6 address autoconfig ipv6 enable ipv6 nd man...
Hello everyone,a bit strange but pppoe doesn't work after change to 15.1.4M9 on 877:"DDR: No free dialer - starting fast idle timer."This is the important part of what was working config:!interface FastEthernet3 switchport access vlan 10 no ip addres...
Hello all,I've got Cisco 877W but it didn't like when I applied what I think is the last firmware for ST Micro - adsl_alc_20190_6.0.010.binAny suggestions?Many thanksDanMy version:#show verCisco IOS Software, C870 Software (C870-ADVIPSERVICESK9-M), V...
Hi all, I want to have few vlans on ASA 5520 but so far no luck to make it work. interface GigabitEthernet0/0 no nameif no security-levelno ip address!interface GigabitEthernet0/0.1mac-address 2222.1000.aaa1vlan 1nameif External-001security-level 0no...
Hello,I've got VPN connection from Cisco 877 to ASA 5520 and on the Cisco 877 I've got SIP device which doesn't has to go through VPN. I assume that for the best audio quality I should bypass the VPN and connect directly to the SIP servers, but how t...
I see. I assume you're refering to the ADSL firware.Well, I've got this one from Cisco http://software.cisco.com/download/release.html?mdfid=279624018&softwareid=282821763&release=6.0.010&relind=AVAILABLE&rellifecycle=&reltype=latestand therefore I w...
Hello, thank you for the suggestion, but as all except management interfaces use IPv6, it should not require NAT at all. I've got /29 IPv4 available as well and I'll allocate it later on, but to get the IPv6 working is priority. Many thanks,Dan
Yes, I have 'same-security-traffic permit inter-interface' as well as 'same-security-traffic permit intra-interface' just to see if it helps, not going to use it in the final config.Thank youDan
Hi all,thank you for the questions.the 0/0 and 0/1 are external interfaces, the 0/2 and 0/3 internal, each of the will go to different switch with different configs.I can ping the gateway when I used the 0/0 interface instead of 0/0.1, which is why I...
