Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to prevent WAE devices from optimizing traffic from end to end and instead having it optimized twice for the same connections?I am trying to set up an optimized Secure FTP connection between one of our offices and their client. However...
I am trying to set up WAAS acceleration for a Secure FTP connection between two locations. I only have a NME-WAE-522 available to be the central manager.However, it appears that the 522 is not supported as a central manager.So my questions are:Is the...
I am working on configuring a ACE module to load balance connections (Outlook clients, and OWA) to the Exchange CAS servers.Does anybody have a working CLI configuration for all or part of this configuration using and ACE module or appliance that the...
I have an NM-1T3/E3 card installed in slot 3 of a 3845. The router sees the card using "show version" or "show inventory". However, I cannot configure the card. I have read that I need to enter "card type t3 3" in config mode. However, that command d...
We have an intermittent issue with some clients not having the CCA agent pop up and run when they connect to the network. Sometimes the same user (using the same PC) will have everything work correctly. The client systems are located remotely from th...
I had another thought, but don't know if it will work.Newer versions of the WAAS software than I am currently running (currently 4.1.5f), such as 4.3.3, will allow me to prevent two WAE's from becoming peers.If I join all the WAE's to the same CM, an...
The firewall is not a Cisco product and has no WAAS capabilities.Directed mode does not work either because the internal network is using private addresses and the firewall does NAT. With directed mode the traffic from the internal network shows gets...
I didn't get any responses to my post. However, I did find a sample configuration for the ACE at the back of the "Cisco UCS and Application Delivery for Microsoft Hyper-V Virtualization of Exchange 2010 with NetApp Storage" document.http://www.cisco....
Unfortunately this router is at a remote location and I will need to have the local point of contact perform your recommended tasks. Will let you know after that has occurred.
