Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an issue on an ASA 5510 that I have noticed today, when I am using the log viewer all of the information recorded only shows the high end source and destination ports. For exampleSource IP 10.10.4.69 Source Port 59886Destination IP 8.8.8.8Des...
I have two sites connected via 2901 routers to a head end with an ASA 5510, the WAN circuits are LES running at 100MB and at the head end we have a 100MB leased line. All WAN circuits are provided wires onlyby another supplier. I have setup the two...
I have several Cisco 877 that I use at branch offices with IPSEC tunnels to our head office and I am trouble shooting through the syslogs when using the "ip inspect log drop" command so I can see if any traffic is being dropped over the tunnels.Altho...
I have been trying to work out how to allow access to a website via https with a failover dsl solution. I have already configured the failover dsl using route-maps and a ip sla track and I now have smtp working on both public IP addresses if the one...
I have a Catalyst 2950 switch that is about three years old now and recently I have noticed poor performance by the switch when I copy or move large amounts of data through the switch, for example I have one server in the switch and another in the ne...
JouniThank you very much, it was indeed the syslog ID that were disabled, the exact range you were mentioning. I enabled these again and I can see the logging I need.Thank you!
Jouni I think you are on to something here. Yes the logging starts with the Built dynamic TCP translation from so I think I am seeing the PAT here.Is there something that I am missing in the logging to see the NAT instead?Kyle
Thanks John, I was thinking it has to be the provider equipment that I do not control that is the issue. I have straight through cables at present and that is due to previous configs in the uk on LES circuits, so I should have thought cross! So my ...
If I set the duplex manually to full for example then the link protocol goes to down, the only option that will bring the link protocol up is for auto negotiation or I set 10MB half duplex on the 2901 and 100MB half duplex on the ASA. I have had th...
Fabrizio,Thanks for your help, the route map has done the trick. I added an ACL for the traffic back from my server and then in the route map set the interface to send the traffic out from instead of the next hop as I have a dynamic ip on this circu...
