Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
May 26 2006 17:52:08 XXXXXXXX : %ASA-2-106006: Deny inbound UDP from fe80::204:ff:fe13:be2f/547 to ff02::1:2/547 on interface outsideI am running an ASA 5510 in transparent mode only two interfaces into a single switch (2924) I am seeing this error m...
Hello has anyone found any config guides for configuring Transparent Firewalling on the PIX appliance. I have 2 535's that I would like to put into transparent mode and can not find any configuration guides for this. Any tips or tricks would be hel...
I have a 6509 with a FWSM running 1.1(3) when I ping. From the MSFC to the FWSMs internal interface i can send an extened ping about 3000 and I have noticed ever 250 pings get dropped. I don't have any issues sending pings through the FWSM out to ot...
I have just installed my first FWSM at one of your internet pops. Pretty simple only inside and outside no dmz (all listed below). I had to put a static address translation so the internet router could talk back into the internal syslog and tacacs ...
- In VMS when you upgrade the Sigs if you have done any modification to a General Signature's Signature Engine. The mods are not save to the upgraded version. It would be nice if changes to a General Sig was saved to your Custom Sigs. - The other thi...
http://www.cisco.com/en/US/customer/products/sw/secursw/ps2120/products_configuration_guide_book09186a0080485008.htmlit figures after about an hour of searching on ciscos site i finally found this. one of these days i must read the logic behind your ...
i would start by checking the time on the 4250 to make sure its the right time. I think the reports give you the time off the sensor not the time on the server.
I consider it as a very dangerous as a security person. The one good thing is your avarage user isn't going to know how to use it but there are sites out there (GoToMyPC) that makes the same issue easy for a normal user to do the same thing (tunnel ...
Yeah I am with scotts post either a bad image or you may need to take steps in the upgrade process. The OS your trying to upgrade too may not be upgradeable from 4.4(5) you may want to read the text file.
