Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I am in a very strange situation , We have ASR 1006 with IOS XE and i want to see the Software License but somehow i cant!!! ...i googled it but i could not find anything.so, could u help me? how can i see the available license on ASR 1006 o...
Hello expert,I have a problem when i tried to install software... i checked the cisco.com "http://www.cisco.com/en/US/partner/docs/routers/access/interfaces/software/feature/guide/ism-sm-sre.html#wp1119304"you can see the command&error at the below.#...
Hello everyone,I want to configure traffic shaping (or bandwidth) on ASR 1006 but somehow it is not working. Interesting ACL is not catch the traffic? You can see the configuration at the below.MY PC(10.200.0.217) ------> FW (with NAT - 194.X.X.X) --...
Hello experts,I have a problem about the WAAS optimization.The topology is...Center: 7200 Router working with WCCP (512 WAE)Edge: 2800 Router working with WCCP (612 WAE)When i tried to reach the Database (behind the 7200 Router) from the Edge site. i...
Hello,I am trying configure to Cisco 880 3G Router (PCEX-3G-HSPA=F1_2_3_22AP C:/WS/F) ***Cisco IOS Software, C880 Software (C880DATA-UNIVERSALK9-M), Version 12.4(22)YB5, RELEASE SOFTWARE (fc2)*** but i have a problem about the configuration. 3G inter...
Hi Zach,it's working now,when i apply the ip wccp command to tunnel interface, with exclude the all telnet and ssh traffic. Optimization working fine, somehow when i have downloaded something from the internet, i cant see the any compression about H...
Hi ZachCenter router IOS version is c7200-advipservicesk9_li-mz.124-11.T.binEdge router IOS version is c2800nm-adventerprisek9-mz.124-9.T2.binAlso you can see the configurations at the attachThanks,My best.CORE WAE CONFIG:Based on the input, the foll...
Hello Zach,Yes, the traffic going over the gre tunnel between the sites. When i tried to apply the "ip wccp redirect 62" command under the tunnel interface. I can not reach the edge router (with telnet, ssh or etc.)I think, the problem occurs from th...
