Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am trying to get a remote access pptp vpn setup from remote windows clients through a pix515e using radius to authenticate to a windows 2000 domain. I am able to establish the vpn connection ok and the radius is authenticating the right domai...
Hello,I am setting up a vpn for remote access to a windows 2000 domain. I am using a pix 515E version 6.3(3) as the connection that users will vpn to. I have been able to establish a vpn to the pix ok but now I need to figure out how to get users log...
Hello,I have a PIX515E running 6.3(1). It was configured when I started this postion and is currently up and running 24/7 at our site. I am trying to enable the builtin PDM but have come across a snag. When I try to connect and launch the PDM I rece...
Conduits were used prior to acl's. As far as I'm concerned there is never a time that a conduit would be preferred. Acl's do the same thing but offer greater control and are the compatible command for use with the PDM and MC. Hope that helps.Joe
Correct.Deny ip any any will drop all traffic not specified above it. But remember that acl's are processed top down until a match is found and then no further acl processing is performed. Hope that helps.Joe
Pix firewalls only have built-in functionality with external URL filtering servers running WebSense OR N2H2. From my experience WebSense is the more flexible of the two. I usually set up a proxy behind the pix and do url filtering there....Hope that ...
To get SNMP going on the pix you need to configure the SNMP-SERVER HOST command which tells the pix what computer is the SNMP management station. You also use the SNMP-SERVER command to configure and enable traps if so desired. Depending which interf...
