Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi folks,these days I am studying in more detail the different Cisco IOS-XE, IOS-XR and NX-OS operating systems, all born from the IOS legacy. To facilitate consultation I have compiled a summary table, which I share in the hope that it can be useful...
Hi folks,on an enterprise site I found the configuration of the scheme below.I can't understand how an ISP can offer a single, specific, static address through each single interface of its gateway router.The fact of knowing that you can't have the sa...
Ciao,I've been trying to give a new life to an 1801 router for a few days now. I replaced the RAM and the Compact Flash card, after having tested it on another device. The router boots, but only in ROMMON mode.I'm currently getting this message: %SMC...
Thanks for the tip Giuseppe.I also imagined that it is a Bridging type, but I do not have access to the equipment (among other things from the manufacturer Hua@@i) to read the type of configuration created.In recent years I have become Cisco-Addicted...
Ciao Rickin response to your questions:- the image is the original that I found in the router's CF- unfortunately the Cisco website for EOL articles does not allow further investigation- I performed the test with the old card but I got the same resul...
Ciao @Joshqun Ismayilov,I reloaded the cookie with the instructions you sent.The message "%SMC-2-BAD_ID_HW: Failed Identification Test in 0/-1/-1" no longer appears.Now it gives me the error "Wrong IOS image for the router".I tried the tftpdnld proce...
