Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 867VAE router on a customer site and ppp will not re-auto connect, the DSL link light is on, as is the DSL act light, we use the same router and config on over 600 hundred sites for the same customer without any problems.
I have changed the ...
Hi,
Can anybody help me with this.
I can remotely get to a customer router, but i'm unable to ssh on to the switch....The message I get is: [Connection to xxx.xxx.x.x aborted: error status 0]
By adding dialer persistent seems to have had an effect. Do I need to remove anything from the dialer Config? or should this be okay
interface Dialer0 ip address xx.xxx.xx.xxx xxx.xxx.xxx.xxx ip mtu 1452 ip nat outside ip virtual-reassembly in encaps...
Hi,
Yes, that is the dialer 0 Config we use on all sites, without any probs. If I added dialer persistent to the dialer, which would I use?
Delay - Specify a delay for nailing up a connection
or use max-attempts - specify the maximum number of retri...
