Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hey folks,i was wondering whether we can convert the following combo from ios to lwapp.....1231G with RM21A radio module works fine in autonomous....Will it work if the same 1231G with RM21A radio module converted to lwapp?12.3(8)JA2 is IOS software ...
hmmm... ok..so to resolve this... we need to use archive download command..is that correct?also did you get any tracebacks in the ap when it is rebooting often... thanksbalag
Sure... i found a strange thing... that might be the clue here...in the show tech of that ap with RM21A inserted.... see below...interface Dot11Radio1
Radio AIR-RM21A, Base Address 001b.d479.ee10, BBlock version 0.00, Software version 5.90.11
Serial ...
Customer is using 1231G ( 2.4 ghz ) single radio ap in autonomous mode and it's running well without any issues....Customer has then inserted RM21A ( 802.11 a) radio module into the card bus of the ap and made 1231G as daul radio ap ( 2.4ghz and 5.0 ...
