Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Sir / MadamWe are operating a network with 120 sites. We have a PIX-515E acting asa hub point and Contivity 100 in the remote offices.At the branch office we use a dedicate IP line (128 K) and at the hub pointa 8 Mbps dedicate IP line, establish...
I need help to find out which version of IOS (feature set) I need toimplement a X25/TCP translation on a CISCO 2600 and CISCO 805routers.Please, where at Cisco WEB site I can found a list of IOS commandsand the software image / feature set that I nee...
I've configure a PIX using IPsec (ESP-DES) and ISAKMP with a non CISCOdevice. Between the equipments a router configured with NAT (Cisco 3620) translates only addresses through a static one-to-one nat rule. It works fine, but I need answer to one mai...
I've configure a PIX using IPsec (ESP-DES) and ISAKMP with a NortelContivity device.Between the equipments a router configured with NAT (Cisco 3620)translates only addresses through a static one-to-one nat rule.It works fine, but I need answer to one...
Hi JoseAs I had mentioned, I prepared a PIX 515E v.7.2(1) at my lab and tried during Monday and Tuesday get the right configuration to permit dynamic tunnels for site to site connections.In my case, we use DLink (DI-804HV) and Nortel (Contivity 100) ...
Hi Jose I noticed your answer only today. Thank you very much, and YES I DID IT!!!! By the way, I think that there are a simple solution for it! I did hundreds of tests using all kind of configurations with no success. Something is wrong! This...
Thank you for your answer.Where can I get these maintenance releases. I found few references to it at Cisco site and no download links...Thank you again, Franzin
Hi I´m with this problem over 2 PIX 515E (failover) 6.3 (3) using Turbo ACL, and dropping all traffic for 3 perimeters every month. Someone has any idea to bypass???
