Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm having an issue getting to enable mode using Cisco Secure ACS 4.2 for authentication using RADIUS (not TACACS+). I've added a user to ACS who is able to log into the switch just fine and I added the $enab15$ user to get to enable mode. The ques...
I've got 2 freshly installed ACS 4.2 for Windows servers and I need to apply the latest patch rollup before I build the configurations. I stopped the ACS services and ran Acs-4.2.0.124.15-SW.exe to install the patches. The application begins runnin...
I finally got the patch to go through. I ended up completely removing ACS then reinstalling it. After that the patch rollup installation went through the first time.
So I've disabled my antivirus and tried the rollup installation again. It fails in the same place -with the database update. Has anyone seen this behavior with updating ACS before?
Erik, Thanks for the feedback. My versions are as follows:Server OS - Windows Server 2003 R2Cisco Secure ACS - 4.2.(0) Build 124I can't really go to 4.2.1 at this time. I need to figure out how to make what we've got work.Thanks, Richard Jaehne
Thanks for the feedback. I attempted the patch rollup install again and it failed in the same place - on the database upgrade. I did think of one thing. Do I need to have my antivirus/protection services disabled prior to installing the rollup?Als...
