Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey guys i have catalyst 2960 and having the following problem on interface fa0/5
I'm getting errDisable state
I tried opening the port normally using no shutdown i get connected and then 5-10 seconds later i get errDisable
i have tried to set the s...
Hello experts sorry if this is in the wrong section but i'm new here
So i'm an IT officer in a company the network is built and based on cisco i have a little to no knowledge regarding to cisco i'm more of a programmer but i decided to start handli...
Ohh i see one last question some of my ports are configured with a security or restriction when i add a pc the port stops can i use this command to remove security:
-no switchport port-security
??
thanks in advance
Thank you very much this solved it i tried it now blinking green and internet access what do you think that caused this issue ? it was working fine all of sudden the internet became so slow i opened the routers client list and there was an unknown ...
It was connected to the patch panel directly to the admins office but stopped all of sudden so i switched to another port in order to open it later on and it's not opening currently (tried to connect directly from port 27 to my laptop using RJ45 but ...
