Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
as cisco firepower 2130 throughput is 10 Gbps raw and 5.4 Gbps NGFW and ISP and 760 Mbps when TLS decryption is enabled . Is this 760 Mbps is the overall throughput of the firewall when TLS decryption is enabled or non TLS traffic can pass through 5....
Dear Team,
I am getting a Bug in cisco ASR 1002 because of which router ESP card gets reset again and again . I am facing this problum in many sites where we have installed ASR router .
Bug is attached as an file
Can you help me to...
Hello, I the case if you use network 10.1.24.2 0.0.0.0 area 0 in R2 . R3 will chose R2 as best path for network 10.1.24.2 because of ospf Inter and Intra area rule always intra area routes are preferredhope it helps
Hi Nirmal,
It should be Area 0. If your Primary site goes down your client will not get isolated only because of DR site will provide all routes only , if it is in Area 0 .
Hope it helps,
Regards
Hello Nirmal,
If you can share network diagram it would be much more clear . As in OSPF Area 0 is a backbone area so it's important that disaster recovery (DR site) should be in Area 0.
Hope it helps
Regards
Dear Alex,
Thank u for your response , I am having IOS (Version 12.2(33)XNF1 on my router , actually as per log there is crypto key failure so SSH is not working if i am enabling telnet router is working fine as I enable SSH I am fac...
