Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can you connect Nexus 5596 ethernet port(1G) to fiber port(1G) on a C6509E with sup720 ?I've tried both with 10G-SR sfp+ and SFP-GE-S sfp but the link is not coming up. Is this allowed or do you have to have 10G module on the C6509E ?
We've pair of C7206VXR NPE-G2s that we're trying to upgrade to ASR1004 that talks to pair of WAE7371s. I've attempted twice to upgrade the routers but failed due to "WCCP" bouncing every minute. TAC suggested that I modify the wccp load balacing feat...
Hello All, I'm hoping that there are other enterprises out there experiencing same problem as we're having with "Input Errors" and "Overrun" onC7206VXR NPE-G1s and G2s. All of our C7200VXRs are experiencing "Input Error" & "Overrun" constanly increme...
Hello,We've a remote site with about 80GBs of data. We're planning to centralize these data in the data center NAS and access the data from a remote site and optimize the data via WAEs.We've WAE574 at a remote and and pair of WAE7371s at the data cen...
I'm running oe574-4.1.3.55 on a WAE574, I've created Standby Group 1 but when I tried to map the virtual-blade to the NIC it failed with following error:GigabitEthernet 1/0 is part of an Standby group. To use this interface in a virtual blade, it mus...
Hello Giuslar,Thank you very much for your comments.We're seeing 13099 input errors / 300923430 packets input.That's 1 input errors per 23K pkts.I understand that connected GigE int on C6500 sends burst of traffic to GigE on C7200.But I'm having har...
Thank you very much for your quick response. I've couple more questions.1. If you're to use the "prepositioning" function, Do you have any control over how much data can traverse over WAN circuit(T1) ?2. How many simultaneous prepositionings ...
Thank you very much for your response.I can rule out congestion or high CPU utilization because Load on the circuit and the CPU utilization is minimal, txload 3/255, rxload 3/255 and less than 1% CPU utilization at the time of BGP flap.
Thank you very much for your reply.We don't have AS number to do BGP yet.Each router has 6M pipe out to single ISP.router1 is connected to ASA outside, router2 is not connected yet.I'm thinking of either connecting router2 to another outside interfa...
