Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I fixed an interface vlan with ipv6 address 2803:6000:15::1/48. I had good results from both routers, but I don´t understand, what is the difference? I also placed the same loopback ip add in the same interface vlan and was working (at the end)It ...
Hi, The ping was unsuccessful.RegardsR1#ping 2803:6000:4::1 source loopback 10Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 2803:6000:4::1, timeout is 2 seconds:Packet sent with a source address of 2803:6000:1::1Oct 23 08:32:43.336 ...
Hi,Ping from R1, the following output is from R2.Oct 22 13:51:29.674 UTC: IPv6-Fwd: Destination lookup for 2803:6000:3::2 : Local, i/f=GigabitEthernet1/1/1, nexthop=2803:6000:3::2Oct 22 13:51:29.674 UTC: IPV6: source FE80::223:4FF:FE17:9780 (GigabitE...
If I do ping without specif souce, it successful, (blue), but if I do ping with souce lo10 isunsuccessful (red)R2# ping 2803:6000:1::1 Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 2803:6000:1::1, timeout is 2 seconds:!!!!!Success r...
