Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have CME on Router 2800 series, and switch 2960 PoE connected to this router.On 2960 switch, there is existing 7945 IP Phone that already work properly and get IP 14.x.x.x from voice vlan 2.Problem is when I add cisco 6921 IP Phone connect to 2960 ...
Dear All,Iam using LMS 3.2. In short, there is 2 type of router, 2800series and 2900series. These device already join to TACACS server. When I try to sync archive I got:- failed on 2900series- successful on 2800seriesI have doing same config (credent...
I use Nexus 7010 on my client.There is using 48port ethernet module as I/O on slot 1 and 2 and then I add new module 48port ethernet module on slot 7 and 8.Some port already use for connection to server (end device) on slot 1 and 2. At this time, nex...
Tira,[ Wed Oct 17 10:10:08 CST 2012 ] INFO [Util : sendMail] : From ID: I agree with Vinod, in your SMTP log there is blank information about the sender email.Can you attach picture of your LMS Admin>sytem>Sytem Preferences?Sory Tira I am not mana...
Hi Tira,Before you doing every SMTP configuration on LMS, make sure your LMS server can access telnet SMTP server port 25.If at this step you have failed, you must check if your LMS server has been trusted on SMTP Server.I have same problem like you...
Hi Vinod,I already Upgrade LMS to LMS 4.1, now I can fetch config for 2900 device.I also configure this on tacacsprompt.ini on LMS 4.1.[TELNET]USERNAME_PROMPT=Username:,username:PASSWORD_PROMPT=Password:,password:Thanks For Your Answer.
Hi, LMS doesnt need authetication, if I see your wireshark image, you have not set email account for your LMS.To set SMTP server and email account go to:1. Admin>sytem>SMTP Default Server, insert your IP SMTP Server. when you klil apply, it will o...
