Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 x 4506's in separate buildings they are connected with a layer 3 trunk and both in different vtp domains.I need to mirror a port on one 4506 onto a port on the other.Doing some research it does not look like RSPAN will work I also looked at ...
I have had a question from our Linux Admin about him seeing traffic not destined for his server passing the NIC on his server and he has concerns.He believes that as it was a switched network his server should only be seeing traffic destined for itse...
What is the best practice to connect two 4506's together between two buildings?There are about 300 users in each building with 100Mb LES cct.Currently it is configured as a trunk.On building one core: interface GigabitEthernet3/4 description 100MB to...
I am trying to troubleshoot an issue where one of our core 4506's has a very slow response time for a couple minutes once a week at exactly the same time. Response times go from <1ms to 1.5s and then return to normal. This affects some servers / serv...
I need to configure a VPN3020 to tunnel everthing from RA clients except a specific internet subnet So I need clients to access all networks except the a.b.c.d/24 network which I need them to access directly from their internet connection. I have pla...
I am not sure what the best practice is? As far as I can tell it is running as a routed link but I don't fully understand what is going on with the config.Roger
I have been doing some reading and it appears that something is hitting the CPU when it should be being processed in hardware?I have been reading thishttp://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a00804cef15.shtml#tools...
that is what I originally tried and it didn't work. So I was racking my brains trying something else. I will revisit it again. thanks for all your advice
Thanks for the info, I have already tried to configure that and it achieves the result partly. I specify the internal networks which get tunneled and everything else can go direct out the clients broadband however I want to limit what goes out direct...
Which bit? The Client config?Where do I configure the exception?I have the networks I do not want to tunnel in the Split Tunneling Network List. Split Tunneling policy set to Tunnel Everything & allow networks in list to bypass tunnel is ticked.Howev...
