Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi allHopefully someone can help me out with an issue. I'm relatively good with general IT, included networks, but this switch makes me think I don't know sh..My setup is:Router/AP (in the living room): 10.0.10.1Wireless Access Point (basement): 10.0...
Hi MaherWell, this is honestly one of my more embarrasing moments...The switch and the router is now working as expected, the problem was a failure in the config of the router, and it is really embarrassing. Incorrectly configured subnet on the route...
Hi MaherI currently have one NAT for VLAN 30 on the router, and that is "Destination: 10.0.30.0/24" and "Next hop: 10.0.10.254".With this I have access to clients on VLAN30 from VLAN10, any other setting breaks the connection between VLAN10 and VLAN3...
HiAdded the config. I have cleared most of the config and are currently only focusing on VLAN 30 to try and get that running before I start on the other ones.As you can see, I have removed some information that is not relevant (some of the ports that...
Hello MaherSorry for the late reply, I have been away for work a few weeks now and haven't been able to look into this until now. Thanks for very specific and useful information, appreciate that.I have been thru the config again and checked what I ca...
Hi allI have done some more testing and troubleshooting without much success, and in order to get it running I have moved the one server I'm working on to VLAN 10.- I have checked static routes on the router, and there is one route for each VLAN poin...