Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, As the title suggest, we are trying to implement dot1x for a WAP device which needs to be on a trunk port (with native vlan), but facing with challenges to achieve it, know it will work if it's a Cisco switch, unfortunately we are not deploying C...
Hi Experts, Trying to deploy certificate from ISE to IOT devices for security purposes, but can anyone share which docs can i refer to ?- create iot device cert from ISE (export to device)- import ISE cert to the device- authenticate based on the cer...
Hello Experts, Controller version : 19.2ISR 4331 : 16.2 Just noticed the under Troubleshooting > Realtime > Ping, Traceroute and other options are greyed out and stated Not Supported. Any idea whether thill will be supported on v20 ? Thanks
Hi, Can i know whether is this supported now ? I've read it's not supported previously but couldn't find an updated release or version when this will. Thanks
Hi Experts, New in SDWAN, and trying to figure out whether the below will be achievable with our environment :- Branches (2 sites) will have only 1 WAN-Internet cloud for connectivity to both DC/Hub and Internet - Hub and Spoke topology (all branches...
I think i managed to get it worked after few tries, as im not sure is the IOT device or ISE configuration issue :1- No separate certificate profile needed (if there's one in place already)2- Create cert via pxgrid (as suggested by you)3- Imported Roo...
Thanks again for some of the troubleshooting steps, i will proceed to to test the port to confirm the IOT dot1x capabilities (well, the vendor did mentioned he tested with others and it worked, and it's configured for dot1x with eap-tls, which ive ch...
This is an existing setup, hence all the relevant NAS-CIsco SW (shared secret) are already in place. Below are the snippets : 1- Certificate Template2- Certificate Profile3- Authentication Policy (apology, have to amend some of the information due to...
Thanks again for your reply, and i did have a look at the video before. Yes, I've done below on the ISE :- Allowed PEAP & EAP-TLS protocol- Authentication Profile matching the Certificate profile ive created matching SAN (created via pxGrid) As for ...
Thanks again for your prompt assistance. Ive managed to get the zip file with all the certs required and imported to the IOT (enabled dot1x).Created Authentication profile based on the Certificate profile (with relevant Authorization profile to permi...
