Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI´m having some problems in creating a VPN Backup tunnel.I have the HQ with a router with a primary circuit on F0/0 and a backup circuit on F0/1Then i have a branch office with a connection to the HQ with a VPN IPSec tunnel.The problem is that the ...
HiMy name is Mário and i´m a CCNA and CCAIWhen i was teaching a class a problem ocurred while configuring two routers with a back-to-back V35 cable.The two serial interfaces that conected the routers were configured with IP address from diferent netw...
I have two routers conected with 3 serial links: - 56Kbps - 12Kbps - 512Kbps I also have Rip going on on the 3 serial interfaces. All the links have the same distance, 1 hop. My question is how can i influence in the router choosing the best route us...
I have two routers conected with 3 serial links: - 56Kbps - 12Kbps - 512KbpsI also have Rip going on on the 3 serial interfaces. All the links have the same distance, 1 hop.My question is how can i influence in the router choosing the best route usi...
Hi DavidThanks for the info, but still not working I created the LoO on the HQ router and could creat the IP Sec tunnel between HQ and Branch.When i shut down the primary interface the tunnel goes down on doesnt install through the secondary link....
Thanks RickThe IP addresses were configured in diferent networks because we were doing a IP address troubleshooting Lab, that told us to put IP addresses from diferent networks in a point-to-point connection and to se what happend.
