Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've just installed an ExpressRoute between our data center and Azure. The ExpressRoute replaced a VPN tunnel between my MX250 HA pair in the data center and a vMX in Azure. Remote sites are connected to the data center MX250 pair hub and spoke VPN. ...
I had this issue as well and had scheduled an outage for this weekend, thinking it applied to the MS version I'm on (17.2.2). As it turns out, all of the warnings for my switch networks are for the CS software, NOT MS software. When I upgraded the 'U...
Are you native IOSXE on the Cat 9300s or did you put them into Meraki with CS software? I have a couple of Cat 9300s stacked and wedged between my MX pair and MS switches, but I'm using extended access lists on the Cat9300s because they are native. I...
This is actually coming from the device itself, not from one of the sensors.If I click the device, I can get this graph with Alarms, Response Time Index, CPU Load Index and Traffic Index:
I monitor my network with PRTG and have all of my MX and MS devices in there. One of the basic things I get for the devices are CPU, response time and a traffic index. There are other sensors for Netflow, etc. as well.
