Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have a pretty simple, MX75 with two MS125 switches.. Trunks from MX to each switch. STP Root is SW1. SW2 event log shows static STP but SW1 looks like it is taking ports up and down. Am thinking of just disabling STP as can't imagine why this is happ...
I've got the following config on my MX75 & MS125s .. these are SW1 and SW2 (VLAN1 is not used for any clients)MX75 P4 - Trunk - to SW1 P1 allowing VLAN 1, 10, 20, 30MX75 P5 - Trunk - to SW2 P1 allowing VLAN 1, 40, 50If I look on the Switch s...
I only got my MX75 a few weeks ago, but just noticed it is using V16 BETA firmware. I have the NO BETA option checked for all devices. The last non-beta version is V15. When a non-beta V16 comes out, will my MX75 install that? Or will it auto-contin...
This can't be right.. do Meraki switches not support a spanning tree per vlan? I can't imagine turning STP on, if this were the case, in a multiple VLAN.. am I missing something?
I'd like the video wall shown continuously without being auto-logged off after the idle time. Is there no way to set this up per user? How does one continuously display the cameras?There was no answer in 2018.. am hoping 3 years later they've tackle...
I have exactly the same issue with Client -> MR44 -> MX75 -> Bell/Aliant network. I've created one SSID and set the Access control to Bridged.. Will report if this worked.. It is specifically a problem with clients inside our Meraki corporate network...
yes.. just checked it out.. the portal works much better on my Mac/Safari browser. I also really like the DeWarp option on one of our fisheye cameras.. nice
From the replies, it seems like this is normal STP behavior. I was worried that the Spanning Tree algorithm was actually disabling and enabling ports.. but it is responding to the ports going into a power-save mode and shutting down or lowering from ...
It looks like there might be small bug in the MS 125 s/w. Sw1 should not be able to see SW2 as a direct client and not at an address 1.1.1.1. The reporting client list tends to change as I flip between the status pages. Also, I'd expect SW1 to see 3 ...
The MX Port that feeds SW1 is shown below to the left. This port carries VLANS 10, 20, 30. VLAN1 is the native for both the MX and Switches.. it was the default and I did not alter it. The Port 1 uplink of SW1 is shown to right and below. Every port ...
