Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I would like to enable OSPF Gracefull Restart on my Cisco 3825 router, however, it's unclear to me if this is possible. "The router undergoing OSPF graceful restart must be capable of performing a stateful switchover (SSO) operation". My understan...
Hi,I have a "Cisco 2-Port T1/E1 Protection Switching RAN Voice/WANInterface Card" and I am trying to get the ports into Data Carrier Detect (DCD) mode. The document indicated that the port is RJ-48C. The pins are as follows:Pinout: PIN1: RX RingPIN2:...
Hi,I have a CESoPSN terminated on a T1 port 0/2/1, See below for configuration.controller T1 0/2/1 linecode b8zs cablelength long 0db cem-group 0 timeslots 1-24interface CEM0/2/1 no ip address cem 0 xconnect 10.221.221.87 100 encapsulation mplsS...
Hi,I'm using Cisco 3825 (revision 1.2), Cisco IOS Software, 3800 Software (C3825-IPRANK9-M), Version 12.4(19)MRI currently have LDP working on two interfaces, and I am also able to configure CESoPSN. The CESoPSN service is using MPLS tunnel, using LD...
Hi,I was hoping someone can provide some information on how to set an IP address on the FastEthernet interface. i.e FastEthernet0/0/3. When I try to set the IP address, I get the following error:"IP addresses may not be configured on L2 links."So I t...
So my loopback cable is correct. But it does not work. And I tried making changes to the timing, but that did not change the status of the port. Any other thoughts?
The port is configured as "Network", which I believe is similar to Ciscos's "trunk". I tried configuring the cisco to both trunk and access, with the same result.I removed it, and it did not make a difference. My understanding is that vlan-id dot1q i...
The interface is configured with dot1q VLAN 100. This interface, is then connected to a router interface which contains an IP address. I need this interface to comunicate to a Cisco router interface, to create an IP network.
I added vlan 100 to the database... still fail.SYS22-Cis#vlan database SYS22-Cis(vlan)#vlan 100VLAN 100 modified:SYS22-Cis(vlan)#exitAPPLY completed.Setting arp to SNAP, was something I thought I would try. I set it back to ARPA. This interface is co...
