verify type of flash modules with supported types. (sh flash all)check your boot-rom version.( sh ver)With earlier versions not all simm's would supported.If you not use "flash-load-helper" flash must be partitioned.kind regards peter
Hello Terry,please read rfc 1219 before you assign your addresses.If you need not more than 254 addresses in each subnet all ranges are ok, for private addresses please use 172.16.x.x. in case of classB networks.Subnet-mask 255.255.255.0 is the easie...
sorry but I'm a little bit confused.Is it possible for you to past ospf and interface configuration from all Routers/Interfaces connected to VLAN 10/20/30to this forum or just send me an email.kind regards Peter