Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,I'm facing a frustrating issue with a Cisco Catalyst 3560 switch. While attempting to upload an IOS image via XMODEM in ROMMON mode, the baud rate was increased to 230400 (set BAUD 230400) to speed up the transfer.Immediately after the co...
Hello everyone,I have a Cisco AIR-CAP2702I-UXK9 access point running firmware version 15.3(3)JK7, connected to a 5520 Controller with firmware 8.10.171.0. The access point successfully connects to the controller, obtains an IP address from the correc...
Hi,I was able to resolve the issue.I set the console baud rate to 9600 on the terminal side, and immediately after powering on the switch, I continuously sent the following command:set BAUD 9600!By spamming this command during the boot process, the s...
@Mark Elsen Apologies for the late response.I tried tapping the space bar during boot as suggested, but unfortunately it did not make any difference — the console output is still unreadable.
Hi @Leo Laohoo Thanks for your response.The switch is already in ROMMON mode. The reason is that the IOS image was not present on the device, so it could not boot.While attempting to transfer a new image via XMODEM, we increased the baud rate from 11...
When I checked as you mentioned, I saw that the operational status of 2.4GHz is active, but the operational status of 5GHz is inactive.I used the command "ap name APd8b1.9016.7574 dot11 5ghz shutdown" to disable and re-enable it, but it did not activ...
