Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello there,Just wanted to provide some steps to troubleshoot M2PA or M3UA/SUA based links. Although it is uncommon to see them flapping, it actually could occur due to different reasons. In case of observing link flapping, I usually follow the below...
Hello all,Just want to inform that this behavior has been studied by ITP Development Team, and I have opened enhacement bug CSCtj74184 that can be seen on the following link:http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fet...
Hello Sanghee,ITP#1 ------------(m2pa)---------ITP#2---------(m3ua)----------IPSPAfter further tests performed, during restart of M2PA link, ITP#2 does not send TFP to ITP#1 corresponding to IPSP (M3UA).This is an expected behavior due to ITP design....
Hello Sanghee,Thanks for the information. The specification that we should look into on this case is ITU Q.704 (Attached on this reply).Over section 13.2.2 there is a list of the conditions when a TFP is sent, and it seems that according to this poin...
Hello Sanghee Han,Regarding your question. I think that under the circumtances mentioned ITP 2 would not send TFP for IPSP; however I would like that you let me know the following:a) Did you shutdown AS on ITP 2, save the config and then reboot the I...
