Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Got my FPR 1010 FTD running between my ISP and UDM PRO all is more or less good.Sry for any stupid questions still a little green in the field.I'm starting to see a high amount of TX retries for my 2 AP's, this has started after the FPR was introd...
Newbie question trying to learn more on FPR setup.I have a setup looking like thisISP -> FPR 1010 FTD (192.168.10.1) -> UDM PRO gateway (10.90.22.1) -> Unifi switchWhen i turn on my NAT rule on my UDM for my Vlan 22 (10.90.22.0/24) im no longer able ...
Well turns out my issue was as simple as just removing the nat on the UDM and correctly adding the appropriate routing on the FPR.Thx all for your replies, issue is resolved.
Maybe some can riddle me thisi have a static route 10.26.xx.xx/24 towards my fpr’s gw. My udm is connected to the fpr on port 2, the interface is set as a switch port with the fpr gw ip. My udm has a ip from this scope so 10.224.xx.xx. I’ve created t...
Well basically im trying to allow my lan network to access the fpr web interface. Im afraid i may have misconfigured something along the way because i just realised that the subnets only have internat access as long as the udm masquerades til ips to ...
