Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Just upgraded my RV220W firmware to version 1.0.5.8 and now I can't connect to AT&T/BellSouth anymore. Reset my DSL modem to remove bridge mode and my credentials work fine connecting in the modem. It worked fine before the new firmware was loaded.
I'm on firmware 1.0.0.26 and I'm seeing frequent drops in the WAN connection. Most network clients don't notice the drop because it reconnects, but the X11 windows server running over a VPN drops the session and I have to re-establish it. Also, at th...
When my RV220W used firmware 1.0.0.26 the PPPoE login to AT&T/Bellsouth DSL worked just fine. I upgraded to version 1.0.1.0 and now it won't connect. The PPPoE connection still works from my prior Linksys router so there wasn't a change on the ISP si...
Hi Marty,Interesting suggestion. Is there something wrong with the MAC address of the WAN in the router? Just curious why this would change this situation. When you say working PC, any PC on the network? There are many.I opened up a case with support...
It's been more than 2 months since this problem was reported. I've logged a case with support and now I'd like to know when firmware will be released that will address the problem. I really thought Cisco cared more about quality than this...
riroe,I tried the different combinations of downgrading the firmware and reseting back to factory defaults and and none of them correctred the problem. I contacted the Support Center you suggested and they said there was no workaround for this issue....
