Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have several WLCs maily 2006 and 4400 series. I am trying to upgarde the software to v 4 from 3.2 and 3.1 via tftp. Everytime i get the error message failed to store in falsh. I have tried several tftp servers from tftpd32 to whitehorn but all ...
make sure you have the following setup correctly:
on devices you are point to PSN ip addresses and not the PANs.
if you are using mgmt interfaces these will be in a vrf. you need to use ip vrf forwarding Mgmt-vrf under aaa group server
You have corr...
You can go to WorkCenters -> Profiler -> endpoint classification where you should be able to add the mac addresses of endpoints and profile them as registered devices. You can use registered devices in authentication and authorisation policies
Hi,You might want to look at static route tracking with sla monitor. You can use icmp to ping an ip address to ISP1 and if ASA sees a drop in ping reply it would populate a backup route in the routing table. Regards
you can use user changable password with acs se or for windows. please look at the following doc:http://www.cisco.com/en/US/partner/docs/net_mgmt/cisco_secure_access_control_server_for_windows/4.2/installation/guide/user_passwords/ucp.htmlregrads
