Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there a client/user report in the WLC2106 that I can view?I have a couple users that are constantly complaining about their wireless connectivity. I would like to be able to have a detailed report on what type of data connection they have during...
So, I am a newbie to the thought behind the networks. I can program a cisco switch, but I'm having a hard time trying to decide what would be the best setup. Any help would be appreciated!Lets say 216WJ is our colo facility that houses our internet...
So, I have 1 Wireless 2106 Controller, 5 Cisco 1142n APs and 1 3502i AP in our office - the 3502i is acting as an AP, not a monitor. Majority of the wireless is used by people using Lync for IMs, phone and desktop sharing. We are downtown Chicago, ...
Our office connects to our colo, which provides our internet connection. AT&T limits the number of MAC addresses. To prevent AT&T from seeing all the MACs on each side of the connection I need to set the switches to route all the VLANS on layer 3. ...
After doing more research, how about using the no switchport feature instead of a VLAN to connect the two sites? Each site will have a different network and the point-to-point created with the no switchport will be on a different network as well.Is ...
After doing some research, I changed all of our APs to H-REAP mode, instead of the default local mode. This improved our wireless network tenfold!!A 2106 Wireless LAN Controller only has 100Mbs ports on them. We are using 1 of those ports to conne...
Ven:I don't think I can get the required info from AT&T, they may figure out what I am doing to avoid the cost for using more MAC addresses than what they allow. If I have 1 3750 at the colo and 1 3750 at the office, couldn't I create a VLAN between...
