About harsh2035

harsh2035 · 12-06-2024

I recently converted a 3802i AP to Mobility Express controller and enabled AUX port to connect a desktop PC with ethernet cable.There is no issue with the connection and VLAN tagging, I could easily configure that RLAN on respective VLAN and the desk...

harsh2035 · 12-07-2024

It's a Layer 2 managed switch where AP and server are connected.If I remove AP and place another Layer 2 switch in place of AP for a trial run to eliminate other variables, then it works so it is certainly AP that is not allowing such a Layer 2 broad...

harsh2035 · 12-07-2024

The Host (PC) is connected via AUX port and the other host (A server machine running WoL service) is connected over a wired network to the same switch where AP is connected.I can ping and exchange data packet in either way when the PC is awake but on...

harsh2035 · 11-20-2024

I eventually figured that this was because of the incorrect POE power supply used.This is mentioned here: https://community.cisco.com/t5/wireless/2802i-ap-also-running-as-controller-not-broadcasting-the-ssid/td-p/3680661 I was using the POE injector ...

harsh2035 · 11-19-2024

Did anybody solve the problem? I have the same issue.I am using Mobility Express 8.10.196.0 on AP2802i.In my case, I can reach to AP with WebGUI and can see that both 2.4G and 5G radios are enabled and SSID are selected to broadcast but I cannot see ...

Member Since	‎11-05-2024 11:23 AM
Date Last Visited	‎12-10-2024 12:11 AM
Posts	5

User Statistics

User Activity

Aironet 3802i Mobility Express 8.10 RLAN WoL issue

Re: Aironet 3802i Mobility Express 8.10 RLAN WoL issue

Re: Aironet 3802i Mobility Express 8.10 RLAN WoL issue

Re: CISCO MOBILITY - AIR-AP2802I - SSID NOT BROADCASTING - BLUE,RED an

Re: CISCO MOBILITY - AIR-AP2802I - SSID NOT BROADCASTING - BLUE,RED an